- 本站编辑：奔驰宝马娱乐官方网站发布日期：2020-03-04 17:13 浏览次数：
As a part of the project supporting most of the time requirements, the project is always expected to be in place in the shortest possible time, while there is a delay in the decision. As a completely hand-made non-assembled product, the post-box has the problem of connection between various parts. To ensure that stainless steel or other materials in the process of transportation was not scratched, because of ultra-high ultra-wide reasons, resulting in the collision or impact, as well as the time limit for the existence of Silica Gel did not occur on a regular basis, the problem, or the paint is not dry and the surface caused by water spray. In order to effectively deal with these problems, it is necessary to set aside enough time after the production process and the booth frame molding and structural stability. There are time gaps in the manufacturing process that allow time to be compressed, as well as time gaps in the customization of common glass or toughened glass. The regular materials can be made a certain amount of stock, so as to more effectively deal with these urgent orders, in the use of structural glue as much as possible to do a molding to dry, then packaging and transportation. Loading in the course of transportation, the choice of the time of transportation and the choice of route all become the details of the whole process, some may be due to improper route selection, resulting in the intermediate change of vehicles so as to increase the wear and tear in transportation. The fixed position of forklift or crane is also a key link to ensure that the post box can be put into use properly. At the same time in the transport to pay special attention to the protection of doors and windows and stainless steel surface.